Filter
Top Products
– 32 –
Verify Ignition Module Safety Lockout Functions
1. Verify ignition module safety lockout functions.
A. Turn the oven on and close the doors.
B. Turn off gas supply to oven.
C. Set the oven control to call for heat, make sure convection fan is running.
D. Remove screw securing control panel door and swing door open to access burner
compartment area.
E. Observe LED on ignition module. After trying to light the burner, the module should lockout
(See following chart.)
F. Turn gas supply back on to oven.
G. Set the oven control to call for heat and make sure convection fan is running and the burner
has established a flame.
H. Turn the gas supply off to the oven.
I. Observe LED on ignition module (Fig. 10). The module should go into lockout. (See
following chart.)
Fig. 10
J. If the results have been obtained, proceed to next preventive maintenance procedure.
K. If the results have not been obtained, contact your local Hobart Bakery Systems service
office.