Filter
Top Products
– 10 –
Programming Menu Buttons
1. Before entering the program mode, you must first press a Menu Button. Press Menu Button #1.
Its LED will light.
2. To enter Program mode, press and hold both and simultaneously until the time display
shows "PROG" (approximately 2 seconds). The LED on Menu Button #1 will start blinking.
3. The Cook function time and temperature will be programmed first.
Press and hold while pressing or to adjust to the temperature desired. Maximum
allowable temperature setting is 480°F; minimum is 32°F.
Press and hold while pressing or to adjust to the time desired. Maximum time
setting is 5 hours, 59 minutes.
4. Program the Grill function for Menu Button #1.
Press .
Press and hold while pressing or to adjust to the temperature desired. Maximum
allowable temperature setting is 480°F; minimum is 32°F.
Press and hold while pressing or to adjust to the time desired.
5. Program the Warm/Hold function for Menu Button #1.
Press .
Press and hold while pressing or to set the temperature for the hold cycle.
You cannot program a time for the hold function. If you try to program a time, the buzzer will
sound for 3 seconds, then shut off. After programming of Menu Button #1 is completed, the time
display will show the current time of day.
6. Press flashing Menu Button #1 to lock in the programmed settings.
After programming, the displays will show the time and temperature programmed for the Cook
function. If you have programmed "0" time and minimum temperature (32°F) for the Cook
function, the displays will show the actual cavity temperature and actual time of day.
7. Continue programming Menu Buttons 2-5 in the same manner.
Verifying Programmed Temperatures and Times
Cook function: Press and hold the desired Menu Button, then press .
Grill function: Press and hold the desired Menu Button, then press .
Warm/Hold : Press and hold the desired Menu Button, then press . Only the temperature will
be displayed in the Warm/Hold function; the time display will show "0".
Starting a Processing Cycle
To start a processing cycle, press the desired Menu Button (its LED will light), then press (its
LED will light). The time display will show the total processing time and will count down to the end
W
W
START
STOP