Filter
Top Products
– 15 –
Thermometer — Displays temperature in degrees Fahrenheit.
Thermostat — 0 is OFF. Turn dial to desired temperature.
USING THE WARMERS (Models W101, W220 and W330)
Fill the warmer drawer with cold water about three-quarters full to minimize steaming. Use softened
water, if available, to reduce lime build-up in the drawer.
Cooked product other than poultry may be held in the warmer for 3 to 4 hours; then it must be
refrigerated.
When holding poultry, it is recommended that the temperature of the warmer be at least 180 – 200°F
and that poultry be held no longer than 2 hours.
Every 4 to 5 hours, add lukewarm water to the drawer as needed. If water evaporates completely,
product will dry out.
CLEANING
WARNING: DISCONNECT ELECTRICAL POWER BEFORE CLEANING.
Allow oven to cool before cleaning.
CAUTION: Do not use oven cleaners. Do not clean with a high pressure hose.
Wash with warm soapy water, rinse and dry or use a commercial glass cleaner.
Clean the control panel with a damp cloth only.
Remove the oven rotisserie, spits, bottom plates, grease drawer, and other removable parts and
wash in a sink with warm soapy water. Rinse thoroughly and dry with a soft clean cloth.
Return the clean drawer to the bottom of the oven. Clean the oven interior with warm soapy water.
Rinse thoroughly and dry with a soft clean cloth. Remove any spillage in the grease drawer and
wipe dry with a clean cloth.
On W101, W220 and W330, remove the water drawer and shelves; wash with warm soapy water,
rinse and dry. If scale builds up on the water drawer or warmer interior, soak with vinegar. Rinse
thoroughly and dry with a soft clean cloth.
CLEANING QUARTZ LAMPS
CAUTION: Do not clean the quartz lamps in the top of the oven with soap and water.
Clean lamps with a cloth soaked in alcohol. Do not touch the lamps with your bare hands. Be very
careful when cleaning or handling the lamps. Lamps can be broken by mishandling.
Monthly, clean the ventilation grate and the fan blades in the top of the oven. Use warm soapy
water, rinse thoroughly, and dry with a soft clean cloth. To reach the fan blades, remove the
ventilation grate by unscrewing the nuts on either side of the vents. Then unscrew the nut in the
center of the fan blade by turning clockwise. After cleaning, reinstall in reverse order.