Filter
Top Products
– 11 –
To Rotate the Wire Cage Assembly to the Rear . . .
Push the Latch in to release the Centering Pin from the Centering Ramp. Note how the
grooves on the nylon Retainers allow the Wire Cage to ride around the circular Ridge
on the planetary Drip Cup. The Wire Cage can rotate 360° to the left or right. When the
Wire Cage returns to the front-center position, the Centering Pin is captured and held
by the Centering Ramp, restricting rotation of the Wire Cage until the Latch is pressed
again.
The Wire Cage must be in the front-center position for the mixer to operate.
To Remove the Wire Cage Assembly for Cleaning . . .
Lower the Bowl. Rotate the Wire Cage to the rear. Remove both Agitator and Bowl.
Return the Wire Cage to the front.
While holding the Wire Cage securely with both hands, use your thumb to push down
on the Black Release Knob. Lower and remove the Wire Cage. Wash it in a sink, rinse
with clear water and dry with a clean cloth.
The stainless steel Splash Guard can be wiped off or washed easily with a cloth or
sponge and warm soapy water. Rinse with clear water. Dry with a clean cloth.
To Reinstall the Wire Cage Assembly . . .
Hold the Wire Cage so its top ring is positioned around the planetary Drip Cup with the
grooves in both nylon Rear Retainers straddling the Ridge on the Drip Cup. Push in the
Front-Center Retainer until it stays in and so that it’s grooves also straddle the Ridge
on the Drip Cup. The Wire Cage is properly assembled when all three Retainers
straddle the Ridge on the Drip Cup in the three opposed locations.
Rotate the Wire Cage out of the way to install or remove the Agitator and Bowl or to add
ingredients.
Return the Wire Cage to its front-center position to operate the mixer.