Filter
Top Products
– 13 –
To Remove Wire Cage Assembly (Fig. 5)
1. Lower the bowl. Remove the accessory and bowl.
2. While holding the wire cage securely with both hands, rotate it to your left until the
front-center retainer shoe reaches the gap in the circular ridge on the planetary
drip cup.
3. Lower the front of the wire cage and move the wire cage assembly slightly to the
rear so the rear retainer shoes clear the ridge of the drip cup. The Wire Cage
assembly can now be removed.
Fig. 5
4. Wash the Wire Cage assembly in a sink, rinse with clear water and dry with a clean
cloth.
5. The stainless steel Splash Guard can be wiped off and/or washed with a cloth or
sponge using warm, soapy water. Rinse with clear water and dry with a clean cloth.
To Reinstall Wire Cage Assembly
1. Position the ring of the Wire Cage assembly so the Front-Center Retainer Shoe
is lined up with the gap in the Circular Ridge on the Planetary Drip Cup.
2. Position the grooves so the rear retainer shoes straddle the Circular Ridge on the
Planetary Drip Cup.
3. Lift the front of the Wire Cage assembly so the Front-Center Retainer Shoe passes
up through the gap in the Circular Ridge on the Planetary Drip Cup.
4. Rotate the Wire Cage assembly to your right until all three retainer shoes straddle
the ridge on the Drip Cup in the three opposed locations.
5. Continue rotating the Wire Cage assembly so the opening is to the front of the
mixer (to install the accessory) or until it stops at the Front-Center Position (Fig 6).