Filter
Top Products
– 4 –
SAFETY INFORMATION.
The information in this manual has been prepared to assist the operator to understand,
maintain and operate the M802CE and V1401CE Mixers. Before installation or operating
for the first time, this manual must be studied to obtain a clear understanding of the mixer
and its capabilities.
To prevent accidents, read, understand and follow all the precautions and warnings
contained in this manual before operating or carrying out any of the cleaning/maintenance
operations. For warning information see the section below and the sections on
INSTALLATION, OPERATION, and MAINTENANCE. The procedures and precautions
contained in this manual are understood to apply to the machinery only when it is used
in the authorized manner. If the machinery is used other than in the authorized manner,
the operator will be responsible for his/her own safety and for the safety of the other
persons who may be involved.
• Ensure this manual is kept in an easily accessible place near the mixer for future
reference .
• All operators must be trained in the safe operation of the mixer.
• Do not remove any covers or loosen any fittings while the mixer is operating.
• Ensure the electrical supply has been isolated before attempting to service or move
the mixer.
• Rotating machinery and electricity are potentially hazardous and may cause injury
if sufficient precautions are not taken prior to operating or servicing the machine.
• Always have your mixer regularly serviced at least twice a year, depending on the
frequency of use.
• Do not hose or pressure clean this appliance. Follow the cleaning instructions
detailed in this manual.
WARNING SYMBOLS.
To identify the safety messages in this manual, the following symbols have been used:
The “Warning” symbol is found primarily where the corresponding
information is important for the safe use of the machinery.
The electrical hazard symbol is used when there are risks of an electrical
nature. Prior to cleaning or servicing the machinery, always disconnect
the power cable from the main supply.
LIABILITY.
Installations and repairs which are not carried out by authorized technicians or the
use of non-original spare parts, or any technical alterations to the machine, may
affect the warranty set out in the standard conditions of sale. This does not affect your
statutory rights. Continued product improvement is a Hobart policy; therefore,
specifications may change without notice.