Filter
Top Products
65
11) Place the lower wash spray arm on the
lower spray arm shaft, and tighten the lower
spray arm nut in the direction of the arrow.
12) Check that the wash spray arms and rinse
spray arms can be turned easily by hand.
13) Insert the drain pipe securely.
14) Lower the rack rail. With the rack rail lifted
up, the door cannot be closed and the unit
will not operate.
B. Self-Cleaning
The self-cleaning function is to rinse the wash compartment with hot water. Use this
function after step 7) of “V.A. Daily Maintenance.”
CAUTION
If a portion control detergent feeder other than concentration sensitive type is
used, turn off the power to the detergent feeder. Otherwise the detergent may
be supplied during the self-cleaning cycle. After the cycle completes, turn the
detergent feeder back on. If this is not practical, consult with an authorized
Hoshizaki service company.
1) Turn on the gas and water supplies and water heater.
2) Pull out the drain pipe.
3) Install the upper and lower rinse spray arms
only, and lower the rack rail. With the rack rail
lifted up, the door cannot be closed and the
unit will not operate.
4) With the door open, move the power switch
(GFCI) to the “ON” position, then press and
hold the “STANDBY/CLEANING” button for 3
seconds. “SC” appears in the display.
Insert Drain Pipe
securely
Upper Rinse Spray Arm
Lower Rinse Spray Arm
Rack Rail