Hoshizaki KM-1601SWH/3 Ice Maker User Manual


  Open as PDF
of 76
 
71
B. Important Notes for Component Replacement
CAUTION
When replacing a component listed below, see the notes to help ensure proper
operation.
Component Notes
Compressor Install a new start capacitor, run capacitor, and start relay.
Thermostatic
Expansion Valve
•Attachthethermostaticexpansionvalvebulbtothesuctionlineinthesamelocationas
the previous bulb.
•Thebulbshouldbebetweenthe10and2o'clockpositiononthetube.
•Securethebulbwiththeclampandholder,theninsulateit.
Hot Gas Valve
Liquid Line Valve
•Replacethestrainerwhenreplacingthehotgasvalve.
•Usecoppertubeofthesamediameterandlengthwhenreplacingvalvelines.
Fan Motor Install a new capacitor.
Pump Motor Install a new capacitor.
Thermistor •Attachthenewthermistortothesuctionlineinthesamelocationastheprevious
thermistor.
•Thethermistorshouldbeatthe12o'clockpositiononthetube.
•Smoothlylltherecessedareaofthethermistorholderwithhighthermalconductive
type sealant. Hoshizaki America part number 4A0683-01 (Silicone Heat Sink Compound
10-8108 manufactured by GC Electronics), KE-4560 RTV (manufactured by ShinEtsu
Silicones), or equivalent are recommended.
•Securethethermistorwiththeholder,theninsulateit.
•Beverycarefultopreventdamagetotheleads.
Thermistor Holder
Cable Tie
Thermistor Lead
Foam Insulation
 previous next