Filter
Top Products
:
\
I
‘)
..
.
me range should be installedin its permanent
positionbefore any pilotsare lit or adjusted.
CAUTION:Make sure the surface burner control
knobs are in the “OFF’ positionsbefore
attempting to light the pilots.
1. Raisethe cooktop.
2. Lightboth pilots with a match.
3. To avoidpilotoutage, use cautionwhen closing
cooktop after fightingpilots.
~ote:Do not leave standing pilotlit in a newly
obstructed or remodeled home or apartment that
rill be unoccupied for more than a month.
~achpilot flame was acljusted at the factory to be
proximately 5/1611tail. A tinge of yellow
appearing at the upper tip is norinal. If you find
pilot adjustment is necessary, follow instructions
at right.
2.
adj
be
smallhole near th; center
ofthe manifoldpanel.
3. To adjust,use a blade-typescrewdriverwith a
shaft diameter ofless than 3/16”.Turn pilot
adjustment screw untilpilotis 5/16’1higl~.Do not
reduce the flameto less than 5/16’1or pilotoutage
may occur.Apilotflameburning higher than
recommended may generate soot (carbonblack)
on the bottom ofyour cooktop.
Lightthe OwenP;i@B
CAmON: Make sure the OVENCONTROL
knob is in the “OFF’ positionbefore attemptingto
fightthe pilot.
1, Removethe broiler drawer by slidingthe
drawer allthe way out and then ring slightlyto
remove itfrom its tracks.
2. Locatethe pilotat the
back ofthe broiler
compartment. me pilot
is attached to the left
side ofthe ovenburner.
3. Lightthe pilotwith a
match. No adjustments ar
required for natural gas.
For LP gas, see Howto
Convert the Range for
Use with LP Gas or
Natural Gas.
I
I
,
I
,
\
---- —- ———- --
--—-—-—--——
—.—.