Filter
Top Products
@See Dimensions and Clearances in this section
for all
rough-inand spacingdimensions.These
dimensionsmust be metfor safeuse ofyotu”
range. The locationofthe electricaloutlet and
pipeopening (see GasPipeand ElectricOutlet
hcations) maybe adjustedto meet spec~lc
requirements.
~The range may be placedwith 011clearance
(flush)at the back walland side
walls of
the range.
LoaTI@H
Do not locatethe range where it may be subject to
strong drafts.Any openingsin the floor or wall
behind the range should be sealed. Make sure the
openings around the base ofthe range that supply
fresh air for combustion and ventilationare not
obstructed by carpeting or woodwork.
PROTECT YOUR FkooR
Yourrange, like many other household items, is
hea~ and can settle into softfloor coverings such
as cushioned vinylor carpeting. Use care when
moving the range on this type offlooring.It is
recommended that the followingsimple and
inexpensiveinstructions be followedto protect
your floor.
The range should be installed on a sheet of
plywood (or similar material) as follows:
men the
flooY coverizg
enh at ti~efiont of the razge, the
area that the range will rest on should be built up
with plywood to the same level or higher than the
floor covering. ~is will allow the range to be
moved for cleaning or servicing.
~ De~}endingon your range, you’llfind the model
3
and serial numbers on a label on the front frame
] of the range, behind the kick pane], storage
~ drawer or broiler drawer.
,.,.,.
,f~
- :,
,,—, -_
QPhillipsand flat-bladescrewdrivers
@Penci]and ruler
~Two pipewrenches (onetorbackup)
~ 1%11open-endor adjustablewrench
~ 3/1611
open-end or socket wrench
~ .Nutd~+iver
ABoBTH@HaLmTERBAksYouMY M&En
~ Gas line shut-offvalve
~ Pipejoint sealant or Unapproved pipethread
tape with Teflon*that resists action ofnatural and
LPgases
~ Flexiblemetal applianceconnector (1/2’1I.D.).
A $foot length is recommended for ease of
instillation but other lengths are acceptable.
Never use an old connector when instalbg a new
range.
~ Flare union adapter for connectionto gas
supply
line (3/411or 11211NPTx 1/211I.D.)
~
Flare union adapter for connectionto pressure
regulator on range (1/211N~ x 1/211I.D.)
*Teflon:Registered trademark ofDuPont
.--,.,-
.
=,L1.~-
,
—
-F&3;J .-
~*:_:. ,;
as)
PREMMTION
.:%:
:
~
QRemove alltape and packaging.Lii up the _~
-:;7$3$
cooktop (on models with dualburners) and
:>-&$
remove any packing material under it. Be sure to
remove plastic fih that covers some chrome
parts (around oven doors, side trim).
~Take the accessory pack out ofthe oven.
-...1
~ Check to be sure that no range parts have come ~
loose during shipping.
--- ~ - -’=-=-
/-.\
-f.
/
\
1
‘>
~
‘..”.,2,
,,,------
\,
/
\
5
L .:
.-.