Filter
Top Products
.—
—..—.—
.
Yoursurfaceburners are lighted
by electric ignition,eliminatingthe
need for standingpilot lightswith
constantlyburning flames.
In case of’a power
failure, you
can light the surface burners on
your range with a match. Hold a
lighted match to the burner,then
turn the knob to the LITE position.
Use
extreme cautionwhen
Iighting
burners this }vay.
Surface burners in use when an
electrical power failure occurs will
continue to operate normally.
The electrodeof the spark
igniteris exposed.
Whenone
burneris turnedto LITE, all the
burnersspark.Do not attemptto
disassembleorclean aroundany
burnerwhileanotherburneris
on. An electricshock may
result, whichcould causeyou
to knock over hot cookware.
surfaceBurner controls
Knobs that turn the surface burners
on and off are marked as to which
burners they control. The two
knobs on
front and
knobs on
front and
the left control the left
left rear burners. The two
the right control the right
right rear burners.
BeforeLightinga Burner
@If drip pans are suppliedwith
your range, they shouldbe used
at all times.
o.Makesure both grates on one
side of the range are in place
before using either burner.
To Light a surface Burner
AfterLighting a Burner
~Check to be surethe burner
you turned on is the one youwant
to
Llse.
~Do
not operate a burner for an
extended periodof time without
cookware on the grate. The finish
on the grate may chip without
cookware to absorbthe heat.
~Be sure the burners and grates are
cool before you place your hand, a
pot holder, cleaningcloths or other
hh
the control knob inand tirn
it to LITE.
You will hear a little
“clicking” noise—the sound of the
electric spark igniting the burner.
After the burner ignites, turn tile
knob to adiust the flame size.
.
..
.I
....=—-....-...——..—,—..—-.
—— . .