Filter
Top Products
IGHT-ESH/ESHS-0010
12
RECOMMENDED ADJUSTMENTS,
VERIFY THAT THE CASE(S) HAVE BEEN LEVELED PROPERLY.TIPS & TROUBLESHOOTING
Before calling for service if something seems wrong, check the following:
1. INSPECT THE GAP BETWEEN THE GLASS PANELS
A. If pinched at the top:
Gap is more narrow at the top than at the bottom.
Then see Item 4 / Uneven Gap.
Back or Top edges of glass
Front or Bottom edges of glass
B. If pinched at the bottom:
Gap is more narrow at the bottom than at the top.
Then see Item 4 / Uneven Gap
Front or Bottom edges of glass
Back or Top edges of glass (hinge side)
C. If gap is even, but too narrow or too wide and conditions are satisfactory then:
Item 6 / Front and Back Adjustment..
Typical gap = 3/16" to 1/4"
2. CHECK CLOSING ACTION OF THE GLASS PANEL
Test each panel by gently pushing it to close. Does the glass panel bounce or wobble as it closes?
Back
edge of glass (hinge side)
Front
edge of glass or grip rail (ESCS)
Rubber gasket or
(surface that glass
closes upon)
View: Top looking down
A glass panel that does not close smoothly and neatly,
most likely is misaligned with the front edge of the
glass and the surface or edge which it closes upon.
Refer to diagram at the right.
To correct problem
Go to Item 5.