Filter
Top Products
Rev. 0108
13
2. Scrub thoroughly, cleaning all surfaces, with soap and
hot water.
3. Rinse with hot water, but do not flood.
4. Apply the sanitizing solution according to Hussmann’s
directions.
5. Rinse thoroughly.
6. Dry completely before resuming operation.
CLEANING PRECAUTIONS
WHEN CLEANING:
• DO NOT WATER OVER 140° F
• DO NOT INTRODUCE WATER FASTER THAN WASTE OUTLET CAN DRAIN
• NEVER ON A SELF CONTAINED UNIT WITH AN EVAPORATOR FAN
• NEVER USE A CLEANING OR SANITIZING SOLUTION THAT HAS AN OIL
BASE (these will dissolve the butyl sealants) or an AMMONIA BASE
(this will corrode the copper components of the case)
TO PRESERVE THE ATTRACTIVE FINISH:
• DO USE WATER AND A MILD DETERGENT FOR THE EXTERIOR ONLY
• DO NOT USE ABRASIVES OR STEEL WOOL SCOURING PADS
(these will mar the finish)
NOTE: SELF-CONTAINED MODELS
The evaporator pan must be monitored for
overflow conditions. Provide drainage if necessary. After
cleaning and rinsing, purge the pan of any standing water.
• Care should be taken to minimize direct contact
between fan motors and cleaning or rinse water.
• Allow the merchandisers to dry before resuming
operation.
• When cleaning lighted shelves, wipe down with a damp
sponge or cloth so that water does not enter the light
channel. Do NOT use a hose or submerge shelves in
water.
CLEANING GLASS & MIRRORS
Only use a soft cloth and mild glass cleaner for cleaning
any glass or mirrored components. Be sure to rinse and/
or dry completely.
Never use hot water on cold glass surfaces! It
may shatter and cause serious injury! Allow glass
surfaces to warm first.
NON-GLARE GLASS
The high optical clarity of this glass is possible due to spe-
cial coatings on the glass surface itself. To preserve this
coating and the optical clarity, keep the glass clean.
Windex
®
or Glass Plus
®
are the only solutions recom-
mended to be used to clean the non-glare glass. The dam-
age to the glass from improper, caustic solutions is irrepa-
rable.
In addition to cleaning the glass with the recommended
product, there are precautions that should be taken when
working and cleaning the inside of the case.
• When cleaning the inside of the cases, we recom-
mend that the glass be fully opened and covered to
prevent solutions from splashing onto the glass and
ruining the coating on the inside.
PLEXIGLASS & ACRYLIC CARE
Improper cleaning not only accelerates the cleaning cycle
but also degrades the quality of this surface. Normal daily
buffing motions can generated static cling attracting dust
to the surface. Incorrect cleaning agents or cleaning cloths
can cause micro scratching of the surface, causing the plastic
to haze over time.
CLEANING
Hussmann recommends using a clean damp chamois, , or
a paper towel marked as dust and abrasive free with 210
®
Plastic Cleaner and Polish available by calling Sumner
Labs at 1-800-542-8656. Hard, rough cloths or paper tow-
els will scratch the acrylic and should not be used.
ANTISTATIC COATINGS
The 210
®
has proven to be very effective in not only clean-
ing and polishing the Plexiglass surface, but also providing
anti-static and anti-fog capabilities. This product also seals
pores and provides a protective coating.
User Information, Cont’d