Jenn-Air JSM900 Mixer User Manual


 
8
To attach the wire whip, flat beater or dough hook
1. Make sure that the touch wheel control is set to “OFF”
and the mixer is unplugged.
2. Press the mixer head release button and lift the mixer
head up until it locks into place.
3. Insert desired attachment onto attachment post and
press upward as far as possible.
4.Turn the attachment clockwise, hooking the attachment
to the post.
5. Be sure the bowl is attached to the mixer before operat-
ing (see page 7).
6. Lower the mixer head by pressing the mixer head release
button and guiding the mixer head down carefully with your hands.
7. Plug power cord into a grounded 3-prong electrical outlet.
8.Your mixer is adjusted at the factory so that the flat beater just clears the bot-
tom of the bowl. Should the flat beater strike the bottom of the bowl or is too
far away from the bowl, clearance can be corrected as follows:
• Lift mixer head.
• Turn the mixer head adjustment screw counterclock-
wise to raise the head and clockwise to lower
the head.
• Make this adjustment using the flat beater until it
just clears the bottom of the bowl.
Injury Hazard – Unplug mixer before inserting or removing attachments. Failure
to do so may result in broken bones or cuts.
Adjustment Screw
WARNING