Jura Capresso 9 Coffeemaker User Manual


 
11
2 Preparation
pt
es
nl
it
fr
ru
en
de
Preparing two speciality coffees at the
touch of a button
The preparation of 2 espressi and 2 coffees follows
this same model.
Example: Prepare two espressi.
Precondition:
READY is displayed.
T Place two espresso cups under the dual
spout.
) T Press the Aroma Boost button twice (within
two seconds) to start preparation.
2ESPRESSI, the preset amount of
water flows into the cups.
Preparation stops automatically.
READY
Aroma Boost
When you prepare an ‘Aroma Boost’ the maximum
possible amount of powder is freshly ground and
extracted to make an extra strong espresso or
coffee.
Precondition:
READY is displayed.
T Place a cup under the dual spout.
) T Press the Aroma Boost button to start
preparation.
SPECIAL, the preset amount of water
flows into the cup.
Preparation stops automatically.
READY
Latte macchiato, cappuccino
Your ENA can prepare a latte macchiato or
cappuccino at the touch of a button. There is no
need to move the glass or cup.
Example: Proceed as follows to prepare one latte
macchiato.
Precondition:
READY is displayed.
T Place a glass under the dual spout.
T Remove the protective cover of the dual
spout.
T Connect the milk pipe to the dual spout.
T Immerse the other end of the milk pipe in a
receptacle with milk (figure: JURA 0.4 litre
stainless steel vacuum milk container).
E Ensure that the filling height of the milk is
no higher than the milk pipe connection on
the dual spout.
( T Press the Latte Macchiato button.
LATTE MAC., the milk foam is prepared.
Preparation stops automatically when the
preset amount of milk is reached.
PAUSE
E There is a short interval while the hot
milk separates from the milk foam. This
allows the typical layers of a latte macchiato
to form. You can choose the length of this
interval in programming mode (see
Chapter 4 ‘Permanent settings in program-
ming mode – Products’).
LATTE MAC., coffee preparation starts.
The preset amount of water flows into the
cup.
Preparation stops automatically.
READY
Permanently setting the amount of water
for the cup size
It is easy to make permanent settings for the
amount of water for all speciality coffees according
to the cup size. Adjust the amount once as shown
in the following example. Every time you prepare a
drink in the future, this amount of water will be
dispensed.