Filter
Top Products
7
USING THE PROCESSING BLADE/
DISCS
ALL BLADES MUST BE HANDLED CAREFULLY AS THEY ARE
SHARP! USING THE PROCESSING/MIXING BLADE
Select either the processing or plastic mixing
blade
Place the processing /mixing blade over the drive
shaft and push down.
Using the slicing/grating discs.
Select the desired slicing/grating disc and
assemble into the disc holder. To fit the stainless
steel disc onto disc holder, fit left side of disc
(when writing is towards you), with locating tab
into holder, then push right side down firmly until
it locks into place. Fit the end without the push
up marking in first. Then push the “push up” side
down firmly until it locks into place.
a.
b.
a.
To remove disc, hold disk away and place thumbs
underneath disc at top of disc marked “push up”
and push out. The disc may be tight for the first
few times.
Correct placement of the processor lid
Place the lid on top of the bowl, align the indicator
line on the lid with the circle on the bowl.
b.
Push down
Locate tab
KFP100_FOODPROC_IB_FA.indd 7 29/5/09 4:27:59 PM