Filter
Top Products
CHOPPING cont,
NOTE: Before opening the Bowl Cover Assembly, turn the unit OFF and unplug
the cord°
9 Toremove bow! cover, unlock by turning clockwise until cover unlatches, and _i1[off
10 Lift the chopping blade by its base and remove, Unlock the Bowl by turning it clockwise,
(see Assembly on pages 4 and 5), and lift off Empty the processed food,
_ ARNING: MultipurposetChopptng Blade is very sharp_ Use caution Iwhen handling.
J
TO SLICE OR SHRED:
_ CAUTION: Make sure control knob switch is turned to OFF and unit is
unplugged before use° Never use your hand to push food into processor°
The use of heavy pressure will not speed operation,
1 Lock the Bowl Ohio lhe Base as described in Assembly,
2 Slide the disc stem down onto the center post of the base, then place the slice/shred
discs, with the desired side facing up for either slicing or shredding, onto the disc stem
and push down, At this point the disc wilt be at the top of the bowl
_ ARNING: Slicing/Shredding Discs is very sherp. Use caution when i
handling,
J
3- Lock lhe Food Pusher onto the movable loop by rotaling counterclockwise until tab Is
under slol in the loop's lid At lhis point, the movable loop works as part of the food pusher
Lock Ihe Bowl Cover Assembly onto the Bowl. Open the Food Chute Lid by pullingout
lhe slide button, and li_tup and out on the looplfood pusher (see Fig, 3 and 3a), and leave
in the open position
4 Fitl lhe food chule with pieces of food such as potato, cabbage, green pepper, whote
lomatn, etc, and lock the food chute lid See the Shredding or Slicing Guide for sizes
of food pieces
5 Close food chule lid and latch into place Plug the power cord intoelectric outlet Biue
Powerlight and blue OFF light should itlumir_ate toshow that the |cod processor is properly
assembred and ready to operate