Filter
Top Products
Remove any residual matter inside the water
supply line after installing the water filter.
1. Plug the refrigerator's power cord into a 3-prong
grounded outlet.
2.
.
J
Turn ON the main water supply and turn ON the valve
to the water supply line.
Flush 3 gallons (11.4 liters) of water through the
dispenser (approximnately 6 minutes). This removes
any contaminants and purges any air in the water
lines.
4. Additional flushing may be required in some
households.
.
Open the refrigerator door and make sure there are
no water leaks coming from the water filter.
Water
NOTE: Be sure to flush 3 gallons (11.4 liters) approximately
6 minutes). This purges any air in the water lines that
could cause the dispenser to drip.
Check the amount of water supplied to the
icemaker.
1. Open the freezer door.
2. Lift the icemaker cover up and out to remove it from
the freezer door.
Icemaker cover
k,_ J
.
• It will take a few minutes to fill the icemaker with
water.
• Do not press the test button continuously when the
tray is filled with ice or water. Water could overflow
or ice jamming could occur.
• When the bucket is not installed, the icemaker
does not work.
• If ICE OFF blinks on the LCD display panel,
reinsert the bucket and/or make sure it is installed
properly.
Press and hold the test button on the icemaker for
3 seconds. The icemaker will automatically fill with
supplied tap water. After the icemaker has completed
filling, check to make sure the amount of water is
correct.
Test button
.
If the water level is too low, the ice cubes will be
small. Contact a plumber to increase the water
pressure to the refrigerator.
Replace the icemaker cover and close the freezer
door.
14