Filter
Top Products
RE OVAL OF PACKAGBNG TAPE:
k
When packaging tape is removed from new appliances, a residue Is sometimes left on t_ieappliance. The safest way
to remove this adhesive, and prevent damageto the product finish, is by using an application of household liquid dish
washing detergent, mineral o1!,or cooking oil. Apply with soft cloth and allow to soak. Wipe with soft cloth. DO NOT
use plastic pad or equivalent. Wipe dry and then apply an appliance polish to thoroughly clean and protect the
surface, This procedure is also safe for the face of microwave doors and other plastic and lexan parts.
NOTE: The plastic tape that is not removed from chrome trim on range parts CANNOT be removed if baked on.
t rl..., iii i1,,i.... iii i i i, i, ii jjl,lll /.." H
MICROWAVE OVEN LAMP
To replace:
1. Disconnect power at main fuse or circuit breaker
panel.
2o Open microwave oven door, then remove the two
Phlllips head screws from the bottom of the grille.
Remove the grille,
3. Remove the light cover by removing the two Phillips
head screws.
4. Remove the tape around the base of the IlghL The
tape Is there to prevent the light from loosening
during shipment and door closings. Removing the
tape may be difficult.
5. Unscrew the bulb carefully. Use a cloth to protect
your hands In case the glass breaks.
NOTE: The light is not standard. Replace it wi_h
a similar 125 volt, 20 Watt bulb,
6. Screw replacement bulb lnto socket and replace llght
cover and grille. Reconnect power to cooking center.
MICROWAVE SHELF ACCESSORY
To position the Microwave Oven shelf, tip the back
s!lg htly and fitthe shelf support guides onto the support
guides located on each side of the oven in the rear.
Next, lower the front until the shelf support guides fit
onto thesupport guides located at each slde ofthe oven
In the front.
When properly positioned, the shelf should fit snugly In
place, be level and not touch the back wall of the oven.
NOTE: If electrical arcing occurs when using
the shelf to cook more than one food at the same
timer turn the oven off. Make sure the shelf is
positioned right.side-up on all four shelf supports
and not touching oven walls.
29 NEMNTt 7-1