Filter
Top Products
AUTOMATICICEMAKER
Toavoidpropertydamage, observe
thefollowing:
> DO NOTforce ice maker arm
down or up....
> DO NOTplace or store anything in
tce storagebin.
Thisice makercreates the ice used in
thedispensing system.
Usinglee Maker for the First Time
> Confirmice bin isin
placeand ice maker
arm isdown.
> After freezer section reaches
between0°to 2°F (-18° to -17° C),
ice makerfills with water and begins
operating.
> Allow approximately24 hoursafter
installationto receive first harvest of
ice.
> Discard icecreated within first 12
hoursof operationto verify system is
flushed of impurities.
OperatingInstructions
> Confirm ice bin is in place and ice
maker arm is down.
> After freezer section reaches 0°to
2°F (-18° to -17° C), ice maker fills
with water and begins operating. You
will have a completeharvest of ice
approximately every 3 hours.
> Stop ice production
by raising ice maker
arm until click is
heard.
> Ice maker will remainin the off
position until armis pusheddown.
IMPORTANT: Ice Cream Shelf should
notbe installed if ice maker arm is in
"off"position.
FREEZER SHELF
To remove and install ._-_ A
clip-mounted
shelves:
> Toremove, pull shelffrom wall
mountingclipsand pull left side of
shelf out of wall mounting holes.
> Toinstall,place shelf in mounting hole
and attach to wall mounting clips.
To remove and install rail-mounted
shelves: _!
> To remove, snap
r,0 ts,deo,s,e, t,,/
from cabinet railing
and remove from wall mounting clips.
To install, replace shelf in wall
mounting clips. Be sure back edge of
shelf is flush with back of cabinet and
snap shelf into cabinet railing.
ICE CREAM SHELF
Ice Cream Shelf
provides a space for
items to be chilled or
frozen quickly.
> Toremove, lift ice cream shelf from
ice bin rails and pull straight out.
> Toinstall, fit shelf over top of ice
maker and lower onto ice bucketrails.
IMPORTANT: Ice Cream Shelf should
not be installed ifice maker arm is in
"off" position.
To: a_oid p_ssi:b!e inju_i :including
deathi do not place g!ass items inice
Cream shelf: Glass objects may
shatter or explode if exposed to
extreme €old:
STORAG[DR#qEB
FREEZER BASKET
To remove and install
basket:
> Toremove, lift
front of basket
and pull out to its full extension.
Liftup front of basketand remove.
> Toinstall, slidebasketintorails at
bottom offreezersection. Liftup front
of basket,and slideto the backof
refrigerator.
ICE STORAGE BIN
The Ice Storage
Bin is locatedbelow
the automatic
dispensing ice
maker.
To
II'1
_rage
remove and install ice storage bin:
To remove bin, remove ice cream
shelf.
Raise ice maker arm to deactivate ice
maker. Lift front of bin and pull out to
its full extension. Lift up front of bin
and remove.
Toinstall, slide bin into rails belowice
maker until bin locksinto place. Drop
ice maker arm to activate ice maker,
and replace ice cream shelf.
IMPORTANT: Ice bin must be locked in
proper place for }_ ___
proper ice
dispensing. If
freezer door
does not close, bin is not in proper
location. Turn auger driver
counterclockwise (as shown) to properly
align ice bin with back of refrigerator.
STORAGE
ADJUSTABLE DOOR
BUCKETS
Door Buckets adjust to meet individual
storage needs.
To remove buckets:
Lift the door bucket up until
it clears the retainerson the
door liner, then pull the
door bucket _
straight out.
To reinstall buckets:
> Slide bucket in above desired door
liner retainer and push down until
bucket stops.
17