Filter
Top Products
@NT.
Ice maker arm is not in correct position.
AND
Ice makeris not
_roducing ice
Water filter indicator light
is red
Refrigerator is leaking
water
Ice forms in inlettube
to ice maker
Waterflowisslower
thannormal
Dispenserwaterisnot
cold
Household water supply isnot reaching
water valve
Copper or plastic tubing has kinks.
Water pressure is too low.
Checkfreezer temperature.
Ice bin is not installed properly
Improper water valve was installed.
Water filter needs to be replaced.
Filter indicator sensor needsto be reset.
Plastictubing was usedto complete water
connection.
Improper water valve was installed
Water pressure is low.
Freezertemperature istoo high.
Water pressure is too low.
Improper water valve was installed.
Copper or plastic tubing has kinks.
Water filter is clogged or needs to be
changed.
Refrigerator has been recently installed.
Water supply in holding tank has been
depleted.
Water has settled into water lines outside
holding tank and has warmed to room
temperature.
Confirm ice maker arm is down. See Freezer Features
section in your owner's manual for details
Checkwater connection procedurewritten in Installing Your
Refrigerator.
Turn off water supply and remove kinks. If kinkscannot be
removed, replace tubing.
Water pressuremust be between20 to 100 poundspersquare
inchto function properly.A minimumpressureof35 pounds per
squareinch is recommendedfor refrigeratorswith waterfilters.
See temperature controls section in Installing Your
Refrigerator to adjust your controls. Freezer must be
between 0to 2° F (-18 to -17 ° C) to produce ice.
See icebin section for proper installation and alignment.
Check water connection procedure in your Installation
Instructions. Self-piercing and%" saddlevalves cause low
water pressure and may clog the line over time. The
manufacturer is not responsible for property damage due
to improper installation or water connection.
Iffilter is not available, replace with bypass filter. See
Dispenser Features section fordirections.
See Dispenser Features section for directions.
The manufacturer recommends using coppertubing for
installation. Plastic is less durable and can cause leakage.
The manufacturer is not responsible for propertydamage
due to improper installation or water connection.
Check waterconnectionprocedure in yourInstallation
Instructions. Self-piercingand %" saddlevalves cause low
water pressure and may clogthe line over time. The
manufacturer is not responsible for property damage due
to improper installation or water connection.
Water pressure must be between 20 to 100 poundsper
squareinch to function properly.A minimum pressure of 35
pounds per square inch is recommended for refrigerators with
waterfilters.
See temperature controls section in Installing Your
Refrigerator to adjustyour controls. Freezer must be
between 0 to 2° F (-18 to -17 ° C) to produce ice.
Water pressure must be between 20 to 100 pounds per
square inch to function properly.A minimumpressure of 35
pounds per squareinch is recommendedfor refrigerators with
water filters.
Check water connection procedure in your Installation
Instructions. Self-piercing and_,6"saddlevalves cause low
water pressure and may clogthe line over time. The
manufacturer is not responsible for property damage due
to improper installation or water connection.
Turnoff water supply andremove kinks. Ifkinks cannot be
removed, replace tubing.
Change water filter.
Allow approximately 12 hours forwater in holdingtank to chill.
Discardfirst glass of water and refill.
Z8