Filter
Top Products
Toremovethe ovenbottom:
1. Removeknurledscrewsholdingdownrearof oven
bottom.
2. Graspovenbottomat fingerslotsoneachside
3. Lift rear of oven bottomenoughto clear the lip or
rangeframe,thenpullout.
Remove Screw
To remove the burner baffle:
1. Use a nut driver to remove the 1/4" hex head screw
shown in the illustration above. Do not remove any
other screws
2. Pull baffle straight out until it is free from the slot that
holds it at rear of oven.
$1 ep ?
Leveling the Range
1. If necessary, remove storage drawer. Pull drawer
out all the way and lift front of drawer up to remove.
2. Use a 3/16" open-end or socket wrench to back out
both rear leveling legs approximately two turns,
3. Use a 1%" open-end or adjustable wrench to back
out the front leveling legs two turns
4. Install the oven shelves in the oven, position the
range where it will be installed
5. Check for levelness by placing a spirit level or a par-
tially filled cup of water on one of the oven shelves° If
using a spirit level, take two readings--with the level
placed diagonally first in one direction and then the other
6, Adjust the leveling legs until the range is level.
7. After the range is level, slide the range away from
the wall so that the Anti-Tip device can be installed
(continued ne_t page)