Filter
Top Products
Setting Surface Controls (cont'd)
To Set the Cooktop Lockout Feature _COOKTOP
The clock @ pad is used to activate the Cooktop Lockout feature which will lock all surface elements from being
accidentally turned ON. This feature will only lock the cooktop.
INSTRUCTIONS
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold _-_ until "CLO" appears (Figure 1). Continue
holding until a second beep sounds (after 3 seconds). If a triple
beep sounds instead, check all surface elements and turn them to
the OFF position and repeat this step. I_1will appear in the display
indicating the cooktop controls and functions are locked out until the
cooktop is unlocked (See Figure 2).
PRESS DISPLAY
@
To turn the Cooktop Lockout Feature OFF:
1. Press and hold _ until "CLO" appears. Continue holding until
a
second beep sounds (after 3 seconds). I_1will disappear from the
display indicating the cooktop may be used normally (See Figure
3).
@
Figure 1
Figure 2
Figure 3
Note: Starting a Self-Clean cycle will automatically turn ON the
Cooktop Lockout feature. The cooktop will remain locked until the Self-
Clean cycle has completed and the oven door has unlocked. If a power
failure occurs after the Cooktop Lockout has been activated, you must
turn OFF the Cooktop Lockout feature before being able to use the
cooktop features again.
How the Electronic Surface Element Controls work when the Sabbath feature is ON.
When your Oven Sabbath feature is ON, the Electronic Surface Elements are also in Sabbath mode. This means that
all electronic surface element control displays show "Sb". The surface elements can be used even if the Sabbath
Feature is on.
To turn ON a Surface Element when the Oven Sabbath Feature is active:
If you turn on a surface element when the oven Sabbath feature is on, the electronic surface element control will record
that request and execute it with a 15-30 second delay. So the element will start heating 15-30 seconds after the surface
element control was turned on. As with the oven control, the surface element display will not show the heat setting
because "Sb" is on in the displays. When necessary, it is possible to adjust the power of the surface elements but there
will be a 15-30 second delay before the adjustment takes effect.
To turn OFF the Surface Element when the Oven Sabbath Mode is active:
To shut off the surface element while the Sabbath feature is ON, proceed as usual but take note that the element will
immediately turn off without any delay.
Note: Refer to page 32-33 to activate the Sabbath Feature.
ii}8;
ZZIIII
13