Filter
Top Products
General Care & Cleaning (cont'd)
Removing and Replacing Warmer (Warm & Ready TM) Drawer
_I_ I _ Electrical Shock Hazard can occur and result
in serious injury or death. Turn the power off at the main
source before cleaning and servicing the warmer drawer.
To Remove Warmer Drawer:
1. _ Turn the power off at the main source before
removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left
glide lever and push down on the right glide lever (See Figure
1).
4. Pull the drawer away from the range.
To Replace Warmer (Warm & Ready TM) Drawer:
1. Pull the plastic slider to the front of the glide slots on each
side of the drawer cavity (See Figure 2).
2. Align the glide on each side of the drawer with the drawer
cavity glide slot.
3. Push the drawer into the drawer cavity until glide levers "click"
(approximately 2"). If you do not hear the glide levers
"click" or the drawer does not feel seated remove the
drawer and repeat steps 1 thru 3.
Note: The Warmer Drawer will NOT operate while inthe "Self-Clean" and "Oven
Lockout" modes
Left Glide Pull up lever
with finger
Pull down lever
with finger Right Glide
Figure 1
Figure 2
Changing the Oven Light
The oven lights will automatically turn ON when the oven door is opened. The
oven lights may also be manually operated by pressing the @ pad.
The oven light bulb is covered with a glass shield. The glass shield can be
removed to be cleaned manually orto change oven light. THIS GLASS SHIELD
MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1. _ Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. To remove the glass shield, lift up on side with gloved finger and use force
to pull shield out.
4. Replace halogen light appliance bulb taking care not to touch the bulb with
your bare fingers. Touching bulb with your skin can leave a film on the bulb
that causes it to burn out quickly.
5. Replace glass shield in opposite order and manner of removal.
Lift backside
of glass shield
and remove it.
Halogen
Light Bulb
44