Filter
Top Products
Setting Surface Controls
Single Elements
Operating Single Radiant Surface Elements
position,
the position and the position.
To Operate the Single Radiant Surface Elements:
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the
pad for the desired element position until a beep is heard.
The display will show .
Note:
element ON will clear.
3. Touch HiLo
4. Each touch of the Hi or Lo pad will decrease or increase the power level from 9.0
through 3.0 by .5 increments. Simmer power levels between 3.0 and will decrease
or increase by .2 increments. Lo is the lowest power level available.
Note: The power level may be adjusted at any time while the element is ON.
5. When cooking has been completed touch the
pad once to turn the element
Each surface element provides a constant amount of heat at each setting. A glowing
red surface heating area extending beyond the bottom edge of the cookware indicates
the cookware is too small for the surface heating area.
Note: The Hot Surface message will be displayed on the control panel as soon as
the element is hot and will remain ON until the heating surface area has cooled
The glass surface may still be hot and burns may occur if the glass surface is touched before it has
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic
wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels