39
Before you call for service
not the result of defective workmanship or materials in this appliance.
Solutions to Common Problems
Oven Control Beeps and
Electronic control has detected a fault condition. Press STOP to clear the display and
STOP
The door was left open and controls set for self-cleaning cycle. Close the door and push
STOP pad.
Range not leveled.
Bad cooking results.
Place oven rack in center of oven.
oven rack.
instructions for leveling the range).
Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets
are square and level. Contact cabinet maker to correct problem.
Surface element does not heat.
in this checklist.
Too low heat setting. Turn control to a slightly higher setting until element comes on.
Surface element too hot or not
hot enough.
Dial markings are an indicator of relative heat settings and will vary slightly.
Voltage is incorrect. Be sure appliance is properly connected to the power source
for service (See back cover).
bottom, evenly balanced medium or heavyweight cookware. Heavy and medium weight
pans heat evenly. Because lightweight pans heat unevenly, foods may burn easily.
itself.
This is normal. The element temperature rises gradually and evenly. As the temperature
rises, the element will glow red. To maintain the selected setting, the element will cycle
turn on.
The warmer element will not glow when turned on. The indicator light will turn on when
the warmer element is on.
