Filter
Top Products
Operating the Triple Surface Element
The cooktop is equipped with a Triple radiant surface element
lights on the control panel at that position are used to indicate
what portions of the Triple radiant element will heat. The
light indicates that only the inner element will heat. The
light indicates that both inner and middle elements will heat
together. The light indicates that all 3 portions of the
settings at any time during cooking.
To Operate the Triple Surface Element:
1. Place correctly sized cookware on the radiant surface
element.
2. Touch and hold the
pad for the Triple element position
until a beep is heard. The display will show .
Note:
request to power the element ON will clear.
The glass surface may
still be hot
Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or plastic wrappings
on top of the range when it is in use.
placed too close to the surface elements.
3. Select the
4) to heat by pressing the
show indicator lights with 3 elements selected).
4. Touch HiLo
5. Each touch of the Hi or Lo pad will decrease or increase the power level
from 9.0 through 3.0 by .5 increments. Simmer power levels between 3.0 and
will decrease or increase by .2 increments. Lo is the lowest power level
available.
Note: The power level may be adjusted at any time while the element is ON.
Each surface element provides a constant amount of heat at each setting.
extending beyond the bottom edge of the cookware indicates the cookware
is too small for the surface heating area.
pad once to turn the
Note:
control will default to the inner coil only. See recommended surface cooking
settings.
Note: The Hot Surface message will be displayed on the control panel as soon as
the element is hot and will remain ON until the heating surface area has cooled
Setting Surface Controls