Filter
Top Products
Removing the left (freezer) door with water line connection
•Puii up the water feed tube while pressing area (Figure 1) as
shown in the figure below.
° NOTE: If a tube end is deformed or abraded, trim the
part away. Disconnecting the tube under the door causes
about 0.13 gallons (0.5 liters) water to flow out. Put a large
container at end of tube to prevent water from draining onto
the floor.
ure 1
(2)
(i)\
(3)
/
(6)
(7)
Type 1
1. Open the door. Remove the top hinge cover screw (1).
2.Use a fiat blade screwdriver to pry back the hooks (not
shown) on the cabinet underside of the cover (2). Lift up the
cover.
3. Disconnect all the wire harnesses (3).
4.Remove the grounding screw (4).
5.Rotate hinge lever (5) counterclockwise. Lift the top hinge
(6) free of the hinge lever latch (7).
NOTE: Regardless of hinge lever type, removal process isthe
same.
CAUTION: When lifting the hinge free of the latch, be
careful that the door does not fall forward.
6.Lift the door from the lower hinge pin being careful to pull
the water lines through the lower hinge pin.
7. Place the door, inside facing up, on a non scratching
surface.
Relnstalling the right (refrigerator) door
/(2)
1. Place the door onto the lower hinge pin.
2.Fit top hinge (4) over hinge lever latch (5) into place. Rotate
lever (3) counterclockwise to secure hinge.
NOTE : Regardless of hinge lever type, installation process is
the same.
3.Hook tab an switch side of corner under edge of wire
opening in cabinet tap. Position cover (2) into place. Insert
and tighten cover screw (1).
Relnstafflng the Jeff(freezer) door
(2)
(I)\
(6)......
(7)
Type 1
/
/
1. Feed the water tubes through the lower hinge pin and place
the door onto the lower hinge pin.
2. Fit top hinge (6) over hinge lever latch (7) and into place.
Rotate lever (5) clockwise to secure hinge.
NOTE: Regardless of hinge lever type, installation process is
the same.
3.Install the grounding screw (4) and connect all the wire
harnesses (3).
4.Hook tab on door switch side of cover (2) under edge of
wire opening in cabinet top. Position cover into place. Insert
and tighten cover screw (1).
5.Reconnect the water tubes by inserting the tubes into the
connectors.
Coilet
Tube --
Insert Line
11