Filter
Top Products
: LOCI< CONTROLS / LOCI<
[_ The LOCI< CONTROLS/LOCK button
HOLD3SECS deactivates the temperature controls
TYPE1 TYPE2and dispenser functions. Press and hold
this button for 3 seconds or until the Loci<indicator light is
lit. To disable the Loci< function, press and hold the LOCI<
CONTROLS/LOCI< button for 3 seconds or until the Loci<
indicator light is off.
Door Alarm
When either refrigerator or freezer door is left open for more
than 60 seconds, an alarm will sound 5 times at 30 seconds
intervals to let you know the door is open. Please contact the
local service center if warning tone continues to sound even
after closing the door.
C.ANOEH_2T_R
FILTER RESET
HOLD 3SECS
° There is a replacement indicator light for the water filter
cartridge on the dispenser.
° Water filter usually needs replacement once every six
months.
° Filter light comes on and blinks to let you know when to
replace filter.
° After replacing filter, press and hold Filter Reset button for 3
seconds to turn off filter status light.
( 1 Ice&Water 1 1 _CE & WATER
(Identify your icon type)
You can select between the water or ice options.
* Select Water, Crushed Ice or Cubed Ice by pressing the
ICE & WATER button to the selection desired. The Water,
Crushed Ice or Cubed Ice icon will light up to indicate
selection.
Cube
TYPE 1 TYPE 2
Selecting this icon indicates that cubed ice will be
dispensed when the dispenser pad is activated.
Water
TYPE1 TYPE 2
Crushed
TYPE 1 TYPE2
Selecting this icon indicates that water will be
dispensed when the dispenser pad is activated.
Selecting this icon indicates that crushed ice will be
dispensed when the dispenser pad is activated.
ADJUSTING CONTROL SETTINGS
Give the refrigerator time to cool down completely before
making final adjustments. It is best to wait 24 hours before
doing this. The initial settings mentioned in CONTROL PANEL
FEATURES section should be correct for normal household
refrigerator use.
The refrigerator control functions as the thermostat for the
entire appliance (refrigerator and freezer sections). The colder
the setting, the longer the compressor will run to keep the
temperature colder. The freezer control adjusts the cold air
flow from the freezer to the refrigerator. Setting the freezer
control to a lower temperature keeps more cold air in the
freezer compartment to make it colder.
If you need to adjust temperatures in the refrigerator or
freezer, start by adjusting the refrigerator. Then wait 24 hours
before checking the freezer temperature. If it is too warm or
too cold, then adjust the freezer control.
Use the settings listed in the chart below as a guide. Always
remember to wait at least 24 hours between adjustments.
CONDITION/REASON RECOMMENDED
ADJUSTMENT:
[]REFRIGERATOR section too
warm.
° Door opened often.
° Large amount of food added.
° Room temperature very warm.
[]FREEZER section too warm/ice
not made fast enough.
° Door opened often.
° Large amount of food added.
° Very cold room temperature
(compressor does not cycle often
enough).
° Heavy ice usage.
° Air vents blocked by items.
[]REFRIGERATOR section too cold.
° Controls not set correctly for your
conditions.
[] FREEZER section too cold.
° Controls not set correctly for your
conditions.
Press the
REFRIGERATOR control
to next coldest level,
wait 24 hours.
Press the FREEZER
control to next coldest
level, wait 24 hours.
Move items out of
airstream.
Set REFRIGERATOR
control to next warmer
level, wait 24 hours.
Press the FREEZER
control to next warmer
level, wait 24 hours.
To dispense water or ice, gently push your cup against the
dispenser pad.
NOTE: Hold your cup in place for a couple of seconds after
dispensing ice or water so the last few drops go in your cup
instead of on the floor.
17