Filter
Top Products
ENSURING PROPER AIR CIRCULATION
In order to ensure proper temperatures, air must flow between
the refrigerator and freezer sections. As shown in the
illustration below, cool air enters through the refrigerator of
the freezer section and moves up. Most of the air then flows
through the freezer section vents and recircuiates under the
freezer floor. The rest of the air enters the refrigerator section
through the top vent.
CONTROL PANEL FEATURES
(Identify your Control type)
Type ]
Type 2
* Do not block any of these vents with food packages.
If the vents are blocked, airflow will be interrupted and
temperature and moisture problems may occur.
IMPORTANT:
Because air circulates
between both sections,
any odors formed in
one section will transfer
to the other. You must
thoroughly clean both
sections to eliminate
odors. To prevent odor
transfer and dried out
food, wrap or cover
foods tightly. (See the
Food Storage Guide
section for details.)
NOTE: If you close the
refrigerator door, you may see the freezer door open and
close again due to pressure from internal air flow.
PRIOR TO USE
1. Clean your refrigerator thoroughly and wipe off: dust
accumulated during shipping.
2. Install accessories such as ice cube bin, drawers, shelves,
etc., in their proper places. They are packed together to
prevent possible damage during shipment.
3. Let your refrigerator run for at least 2 or 3 hours before
puffing food in it. Check the flow of cold air in the freezer
compartment to ensure proper cooling.
Your refrigerator is now ready for use.
REFRIGERATOR AND FREEZER CONTROLS
It's recommended to maintain the initial temperatures setting
(middle) by pressing Fridge Temp graphic and Freezer Temp
graphic.
NOTE: When changing control settings, waif 24 hours before
making additional adjustments. After 24 hours, adjust the
compartments temperatures as desired. The more lit bars, the
colder the refrigerator and freezer will be. See Figure ] for
reference.
Figure 1
Display Off Mode
The display lights up and stays lit when the refrigerator is
plugged in for 20 seconds. All the display lights go off: except
the dispenser icon selected (crush, water or cube), and the
display only lights when door is opened or display button is
pressed. The display will turn off: 20 seconds after the door
is closed or the display button is pressed. You can change
the display to always ON by pressing the Freezer Temp and
Ultra Ice buttons at the same time for 5 seconds. A tone will
sound indicating that the display is ON ( Display Off: Mode
Deactivated). To return to Display Off: Mode, press the same
two buttons for 5 seconds.
..... ULTRA ICE
Press this button once to activate increased ice
making function. The ULTRA ICE icon on the display
panel will illuminate when activated. The Ultra Ice function
runs the freezer compartment at the coldest settings for a 24
hour period to increase ice making. Press the button again to
cancel the Ultra Ice function.
16