Filter
Top Products
Excessive Weight Hazard
Use two or more people to move and install the refrigeraton
Failure to do so can result in back or other injury.
UNPACKING YOUR REFRIGERATOR
Remove tape and any temporary labels from your refrigerator
before using. Do not remove any warning type labels or the
model and serial number label, or the Technical Data sheet
located under the front part of the refrigerator, behind the
base grille.
To remove any remaining tape or glue, rub the area briskly
with your thumb. Tape or glue residue can also be easily
removed by rubbing a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and
dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see the Important Safety Instructions
section.
Refrigerator shelves are installed in the shipping position.
Please reinstall shelves according to your individual storage
needs.
When Moving Your Refrigerator
Your refrigerator is heavy. When moving the refrigerator for
cleaning or service, be sure to protect the floor. Always pull
the refrigerator straight out when moving it. Do not wiggle
or wall< the refrigerator when trying to move it, as floor
damage could occur.
ExpNoslon Hazard
Keep flammable materials and vapors, such as gasoline,
away from refrigerator.
Failure to do so can result in death, explosion or fire.
INSTALLATION
1.Avoid placing unit near heat sources, direct sunlight or
moisture.
2.To minimize noise and vibration, the refrigerator MUST be
installed on a solidly constructed floor.
3.Carpeting and soft tile surfaces are not recommended.
4.NEVER install the refrigerator on a platform or a weakly
supported structure.
5.Install this appliance in an area where the temperature is
between 55°F (13°C) and 110°F (43°C). If the temperature
around the appliance is too low or high, cooling ability may
be adversely affected.
NOTE: For proper air circulation, best cooling and energy
consumption results, maintain a minimum distance of 2 inches
(5.08 cm) from adjacent items and surfaces.
(
2"(5.08cm) _" _ 2"(5.08cm) -_ _-2"(5.08cm)
2"(5.08 cm)i
" Be careful when you work with hinge, base grille, stopper,
etc. You may be injured.
° Do not put hands or metal sticks into air vents, base grille
or bottom of refrigerator. You may be injured or receive an
electrical shock.
BASE GRILLE INSTALLATION
To install or replace base grille:
1. Remove the 2 screws from the bottom front part of
refrigeraton
2. Place base grille into position and insert and tighten screws.
To remove the base grille:
1.Open the doors, (refrigerator and freezer).
2.Once doors are open, remove screws from base grille.
Remove base grille and set safely aside.
3.Reattach screws to the base of refrigerator.