Kenmore 795.5131 Refrigerator User Manual


 
WATER AND ICE DISPENSER
Your refrigerator has a mechanism that can dispense cool
water and ice cubes without opening the door.
° The tray can easily be removed by pressing down and lifting
it out.
ICE STORAGE BIN
The ice bin stores the ice cubes made by the icemaken If you
need to remove the ice storage bin, do so as follows.
NOTE: Use both hands to remove the ice bin to avoid
dropping it. If the ice bin does not slide into place easily, twist
the drive device slightly.
° Hold the ice storage bin as shown in the left figure lift it @
while slightly pulling it out @.
° First push the tray in the area labeled 'PUSH', then place
your finger in the center hole and lift up to remove the tray.
®
° To assemble the ice storage bin, lift it (3) while slightly
pushing it in @.
Ll_ WARNING: Do not put your hands into the water and ice
dispenser opening. Doing so may cause an injury to your
hand.
I NOTE: Make sure the bin is fully engaged into the auger drive
@. If not, rotate the auger drive in the direction shown by the
arrow until the bin is fully engaged into the auger drive.
ICENAKER COVER
If you need access to the icemaker, follow these steps:
CAUTION: When using the dispenser with a container with Lift the ice shelf @ and pull it out @.
a small opening, place the container as close to the top as
possible.
° The dispenser has the following dimensions:
Depth 4 _?' (124 mm)
Width 6 z,/d' (175 mm)
Height 9 _d' (238 mm)
We suggest you use a container that is within the
specifications for better performance.
DOOR RACK AND SUPPORT
Your refrigerator and freezer features racks which can easily
be arranged for packaged products.
° Lift the door rack holding both sides @ and puii it out in @
direction.
19