Filter
Top Products
16
using the two front ribs as a guide, and snap
them into place from the top.
2. Cleaning the Funnel —The Funnel can be
removed from the K-
Cup Holder by pulling
on it until it pops off (fig. 24). The Funnel is
dishwasher safe. To replace it, just snap it
back onto the K-Cup Holder.
3. Cleaning the Exit Needle —The Exit Needle
is located on the inside bottom of the K-Cup
Holder. Should a clog arise due to coffee
grinds, it can be cleaned using a paper clip
or similar tool. Remove the K-Cup Holder
Assembly and detach Funnel. Insert the
paper clip (as shown in fig. 24) into the
Needle to loosen the clog, then flush
with water.
The K-Cup Holder Assembly can be
placed onto the top shelf of a dishwasher.
NOTE: Use low temperature cycles in the
dishwasher
.
CAUTION: There are sharp needles that puncture the K-Cup above the K-Cup
Holder and in the bottom of the K-Cup Holder. To avoid risk of injury, do not
put your fingers in the K-Cup
Assembly Housing.
SECTION 3 Cleaning & Maintenance (continued)
!
fig.
24
Cleaning the Water Reservoir & Water Reservoir Lid
The Water Reservoir Lid or Water Reservoir should not be put into the
dishwasher. They should be cleaned with a damp, soapy, non-abrasive cloth
and rinsed thoroughly. Do not dry the inside of the Water Reservoir with a
cloth as lint may remain.
CAUTION: Please rinse the Water Reservoir
thoroughly after cleaning to ensure
that no cleaners or cleaning solutions
remain in this area as they may contaminate the water supply in the Brewer.
De-Scaling Your Brewer
Mineral content in water varies from place to place. Depending on the mineral
content of the water in your area, calcium deposits or scale may build up in
your Brewer. Scale is non-toxic, but left unattended, it can hinder Brewer
performance. De-scaling your Brewer helps maintain the heating element
and other internal parts of the Brewer that come in contact with water.
The Brewer should be de-scaled every 3-6 months to ensure optimal
performance. It is possible for calcium deposits to build up faster, making it
necessary to de-scale more often.