Filter
Top Products
Stopping the Brew Process
If you need to stop the brewing after the process has started, press and
release the Power Switch to turn the Brewer ‘OFF’. The flow of coffee, tea or
hot cocoa will stop and the heating element and the LCD Screen will shut off.
NOTE: You may get more coffee, tea or hot cocoa in your cup during your next
brew. We recommend that you perform a cleansing brew with water only after a
terminated brew. Then your next brew will be the volume you have selected.
Adding Water
The LCD Display of your Brewer will indicate
when the water level in the Reservoir is low
or if the Water Reservoir has been removed by
displaying the words “FILL WATER RESERVOIR”
(fig. 9). The Brewer will not allow you to brew
when “FILL WATER RESERVOIR” is displayed
(fig. 9).
The Water Reservoir can be filled in three ways.
1. Remove the Water Reservoir from Brewer by
first removing Lid from the Water Reservoir,
then lifting the Water Reservoir straight up
and toward the right of the Brewer. Fill with
water. Place the Water Reservoir back on the
Brewer and replace the Lid.
IMPORTANT: Do not remove the Water Reservoir
during the brewing process.
2.
Lift off the Water Reservoir Lid and pour
water directly into the Water Reservoir
while it is still attached to the Brewer,
then replace the Lid.
3. The Brewer can also be connected directly into
the water line. To order a B150 Direct Plumb Kit
please call 1.888.CUP.BREW (287.2739).
SECTION 1
Set-Up & First Brew (continued)
fig.
9
8
2. Fill Water Reservoir