Filter
Top Products
7. There may be a short pause prior to coffee
being dispensed. The entire brew process
lasts for approximately 1 minute and ends
with a burst of air to remove all liquid from
the K-Cup.
CAUTION: There is extremely hot water in
the K-Cup Holder during the brew process.
To avoid risk of injury, do not lift the Handle
or open the K-Cup Assembly Housing during
the brew process.
8.
The end of brew is indicated by “KEURIG
BREWED ENJOY”.
9. Lift the Handle, remove and dispose
of the used K-Cup.
CAUTION: K-Cup will be hot.
10. Enjoy your first cup of Keurig Brewed
®
gourmet coffee, tea or hot cocoa!
11. Your Brewer may display “HEATING
PLEASE WAIT” as it heats water for the
next brew cycle.
Ready to Brew Your First Cup
1. The LCD Display will be in its idle state (fig. 4).
2. Lift the Handle. The K-Cup
®
Holder
will open toward you (fig. 5).
3. Select a K-Cup portion pack.
NOTE: Do not remove the foil lid
or puncture the K-Cup.
4.
Place a K-Cup portion pack
in the K-Cup Holder (fig. 6).
CAUTION: There are two sharp needles that
puncture the K-Cup, one above the K-Cup Holder
and the other in the bottom of the K-Cup Holder.
To avoid risk of injury, do not put your fingers in
the K-Cup Assembly Housing.
5.
Lower the Handle to close the Lid over the
K-Cup Holder. (When it is closed completely,
the BREW Button will flash up to 60 seconds.)
6. Place a mug on the drip tray and select
your brew size (fig. 7), then press BREW (fig. 8).
NOTE: If you do not press BREW within 60
seconds the Brewer will return to its idle state
and the Brew Button will cease to flash to prevent
accidental activation. Re-activate by raising the
handle fully and then closing it.
fi g.
4
fi g.
6
fi g.
5
fi g.
7
7
fi g.
8
12:30 PM
Ready
Choose Your
K-Cup
®
&
Lift Handle
WATER
LEVEL
Español Français
Select
Brew Size
4 OZ.
12 OZ.
6 OZ.
10 OZ.
8 OZ.