Filter
Top Products
Downdraft Vent (cont.1
If downdraft vent is installed next
to another aDr>liance in the same
cutout, go to Step 11.
If downdraft vent will be installed in a
separate cutout (no other appliances in same
cutout), remove the motor from the blower box.
Carefully insert the blower box into the
countertop cutout.
Lift motor up and place on blower box. Connect
the motor and power supply wiring as described
instepsll-16and18-21.
Use all four nuts to attach the motor to the blower
box. Use a 10 mm or 3/8” ratchet to tighten the nut
located inside the duct opening. Be sure to tighten
this nut or vibration may occur, causing noise
during operation.
Threads from the motor conduit throuih
conduit connector and through the opening of the
wiring box. Tighten the conduit connector screws.
cable
Connect the red wire from the motor to the red
wire from the control with a twist-on wire
connector.
Power supply
Disconnect power supply. Thread the power
supply cable through the conduit connector.
Tighten the screws on the conduit connector.
Connect the two, white wires together with a
twist-on wire connector.
Connect the black wire from the power supply
cable to the black wire of the control with a twist-
on wire connector.
Connect the three, green ground wires together
with a twist-on wire connector.
rubber cap
capacitor. Thread the two, brown
wires with spade terminals through the rubber
cap of the capacitor. Attach one wire to one of
the inside capacitor terminals. Then attach the
14