Filter
Top Products
8
Sound (Tones)
Tones are audible signals, indicating the following:
One beep
■ Valid key touch
■ Function has been entered
One chime
■ Preheat cycle has been completed
Two chimes
■ End of a cooking cycle
Three beeps
■ Invalid key touch
Four chimes
■ When timer reaches zero
Includes using the Timer for functions other than cooking.
Tone Volume (Sound)
■ The preset volume can be changed. On double ovens, you
can change the sound from either display. Changing the
sound on one display changes the sound for both ovens.
To Change:
1. From the Main menu, touch MORE.
2. Touch SETTINGS.
3. Touch SOUND.
4. To change the sound level, touch the “plus” (+) or “minus” (-)
signs to increase or decrease to the desired level.
5. Touch OK.
NOTE: To turn the sound off touch - until the bar disappears
to the left.
Display Contrast
To Adjust Display Contrast:
1. From the Main menu, touch MORE.
2. Touch SETTINGS.
3. Touch DISPLAY CONTRAST.
4. Touch + (plus) or - (minus) to increase/decrease the display
contrast to the desired setting.
5. Touch OK.
Temp Format (Fahrenheit and Celsius)
The temperature is preset in Fahrenheit, however it can be
changed to Celsius.
To Change:
1. From the Main menu, touch MORE.
2. Touch SETTINGS.
3. Touch TEMP FORMAT.
4. Touch °F (Fahrenheit) or °C (Celsius).
5. Touch OK.
Calibration (Oven Temperature Control)
IMPORTANT: Do not use a thermometer to measure oven
temperature because opening the oven door during cycling may
give incorrect readings.
The oven provides accurate temperatures; however, it may cook
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit or
Celsius.
A minus sign means the oven will be cooler by the displayed
amount. The absence of a minus sign means the oven will be
warmer by the displayed amount. Use the following chart as a
guide.
To Adjust Oven Temperature Calibration:
1. From the Main menu, touch MORE.
2. Touch SETTINGS.
3. Touch CALIBRATION
4. Touch the + (plus) or - (minus) to increase or decrease the
temperature.
5. Touch OK.
Water Filter/Filtration System
The Water Filter setting allows you to check the status of the
water filter and reset the system after the filter has been replaced.
IMPORTANT: The oven will shut off the steam functions until the
filter is replaced.
To Check Filter Status:
1. From the main menu, touch MORE.
2. Touch SETTINGS.
3. Touch WATER FILTER.
4. The status will be displayed. There are 3 water filter states:
Good, Replace Filter Soon and Replace Filter. If the filter
status is Replace Filter Soon or Replace Filter, the Reset key
becomes available.
NOTE: See “Water Filtration Replacement” section.
5. After replacing the filter, touch and hold RESET for
approximately 3 seconds to reset the system. The status will
change to Good.
NOTE: If you reset the system without replacing the filter, the
system will continue to notify you that the filter needs to be
replaced. The oven will shut off the steam functions until the
filter is replaced. Continuing to reset the system without
replacing the filter may cause damage to the oven.
For information on ordering replacement filters, touch ORDER
INFO or see “Assistance or Service” section.
ADJUSTMENT °F
(AUTOMATIC °C CHANGE)
COOKS FOOD
10°F (5°C) ...a little more
20°F (10°C) ...moderately more
30°F (15°C) ...much more
0°F (0°C) default setting
-10°F (-5°C) ...a little less
-20°F (-10°C) ...moderately less
-30°F (-15°C) ...much less