LG Electronics LRG30855ST, LRG30355ST, LRG30355SW, LRG30355SB Range User Manual


 
44
BEFORE CALLING FOR SERVICE
Problem Possible Causes Solutions
Oven door will not open Oven too hot. Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after a Oven controls not properly set. See the Using the Self-Cleaning Oven section.
clean cycle
Oven was heavily soiled. Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“LOCK DOOR” flashes The self-clean cycle has been Close the oven door.
in the display selected but the door is not
closed.
LOCKED DOOR light The oven door is locked Touch the CLEAR/OFF pad. Allow the oven to cool.
is on when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
“F—and a number or
You have a function error code. Touch the CLEAR/OFF pad. Allow the oven to cool for
letter” flash in the display
one hour. Put the oven back into operation.
If the function code repeats. Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Oven shelves are The nickel shelves (if so equipped) Apply a small amount of vegetable oil to a paper
difficult to slide were cleaned in a self-clean cycle. towel and wipe the edges of the oven shelves with
the paper towel. Do not spray with Pam
®
or other
lubricant sprays.
“Probe” appears
This is reminding you to enter a Enter a probe temperature.
in the display probe temperature after plugging
(convection models) in the probe.
Display goes blank A fuse in your home may be blown Replace the fuse or reset the circuit breaker.
or the circuit breaker tripped.
The clock is in the See the Special Features of Your Oven Control
black-out mode. section.
Display flashes Power failure. Reset the clock.
Unable to get the
Oven control pads were
The
BAKE and BROIL HI/LO pads must be touched
display to show “SF” not pressed properly. at the same time and held for 3 seconds.
Power outage,
P
o
wer outa
ge or surge.
Reset the clock. If the oven was in use, you must
clock flashes reset it by touching the CLEAR/OFF pad, setting the
clock and resetting any cooking function.
TROUBLESHOOTING