Problem Possible Cause Correction
A faint clicking
sound
The sound always occurs when the
refrigeration unit (the motor) auto-
matically switches on or off.
u
The sound is normal.
A hum. It is
briefly a little
louder when the
refrigeration unit
(the motor)
switches on.
The refrigeration increases automati-
cally when the SuperFrost function is
activated, fresh food has just been
placed in the appliance or the door
has been left open for a while.
u
The sound is normal.
The refrigeration increases automati-
cally when the SuperCool function is
activated, fresh food has just been
placed in the appliance or the door
has been left open for a while.
u
The sound is normal.
The ambient temperature is too high.
u
Solution: (see 1.3)
A low hum
The sound occurs as a result of fan
air flow.
u
The sound is normal.
Flow noise on
the soft stop
mechanism.*
The sound is caused by the soft stop
mechanism.
u
The sound is normal.
The temperature
display indi-
cates: F0 to F5.
There is a fault.
u
Contact the customer service department (see Main-
tenance).
The temperature
display indi-
cates: nA.
The freezer temperature rose too
high during the last hours or days
due to power failure or power inter-
ruption. When the power interruption
is over, the appliance will continue to
operate at the last temperature
setting.
u
Press the Alarm button
Fig. 2 (1)
.
w
The warmest temperature reached during the power
failure is displayed in the temperature display for
about 60 seconds. Then the electronics again indi-
cate the current freezer temperature
u
To delete the display of the warmest temperature
ahead of time: Press the Alarm button
Fig. 2 (1)
.
u
Check the quality of the food. Do not consume
spoiled food. Do not re-freeze defrosted food.
The outside
surfaces of the
appliance are
hot*.
The heat of the refrigerant circuit is
used to prevent condensate from
forming.
u
This is normal.
The IceMaker
cannot be
switched on.*
The appliance and therefore the
IceMaker are not connected.
u
Connect the appliance (see Start-up).
The IceMaker is
not making ice
cubes.*
The IceMaker is not switched on.
u
Switch the IceMaker on.
The drawer of the IceMaker is not
properly closed.
u
Close the drawer properly.
The water connection is not open.
u
Open the water connection.
The water supply to the IceMaker
was interrupted.
u
Check the connection to the water supply (see the
Assembly Instructions, Connecting the Water
Supply).*
u
Check the pipes and hoses (see the Assembly
Instructions, Connecting the Water Supply).*
Troubleshooting
* Depending on model and options 15