Filter
Top Products
Impinger I -–1000 Series Service Manual - International 61
1 24V
2 24V
24V
24V (GND)
MV
MV/PV
PV
GND
BLUE FROM VALVE
BLACK FROM VALVE
#3 RED FROM VALVE
TO PILOT LIGHT
BUTT SPLICE AND
NEW GREEN WIRE
SUPPLIED IN KIT
WHITE FROM
PILOT LIGHT
2 MV/PV
4 GND
1 MV
3
PV
5
6
24V
24V GND
9
SPARK
IGNITOR/SENSOR
CABLE
FROM BLOWER
CENTRIFUGAL SWITCH
#3 RED FROM VALVE
TO PILOT LIGHT
BLACK FROM VALVE
BLUE FROM VALVE
RING TERMINAL END OF
WIRE HARNESS SUPPLIED IN KIT
BUTT SPLICE AND NEW
GREEN WIRE SUPPLIED
IN KIT
WHITE FROM PILOT LIGHT
24V FROM TRANSFORMER
INSULATED MALE TAB
CONNECTOR
FLAME SENSOR
1. Shut off power at main breaker.
2. Remove control panel top and front cover.
3. Remove burner assembly (see burner assembly).
4. Disconnect one (1) wire from flame sensor.
5. Remove flame sensor by removing one (1) mounting nut.
6. Reassemble in reverse order.
NOTE: Be sure flame sensor is not bent or touching any other burner parts.