Filter
Top Products
ITEM
1
2
3
4
5
QTY.
1
2
2
1
1
PART NO.
98-1421
98-1523
98-1191
08-7839
S-4839
DESCRIPTION
GAS STRAIN RELIEF KIT FOR CASTER UNITS
CASTER WITH BRAKE
CASTER WITHOUT BRAKE
EYE-BOLT, 1/4-20 X 2" LG.
INSTALLATION INSTRUCTIONS
OPTIONAL CASTERS WITH GAS STRAIN RELIEF
INSTALLATION INSTRUCTIONS FOR CASTERS ON THE UNIVERSE SKILLET
FORM NUMBER: S-4839
WARNING: Before raising skillet base make sure the pan is in the down position for steps 1-8.
1. Raise the front of the skillet base and brace with front of skillet off the ground.
2. Insert casters with brakes into the front legs of the frame
NOTE: Casters must screw fully into the frame of the skillet in order for them to be able to be tightened.
3. Tighten the nut at the base of the casters until casters are securely fastened into the legs of the frame.
4. Put the universe skillet down on the floor.
5. Apply the brakes in the front by stepping on the lever on the side of the front casters until it is in the on position.
6. Raise the rear of the skillet base and brace with rear of skillet off the ground.
7. Insert casters without brakes into the rear legs of the frame
NOTE: Casters must screw fully into the frame of the skillet in order for them to be able to be tightened.
8. Tighten the nut at the base of the casters until casters are securely fastened into the legs of the frame.
9. Put the Universe Skillet down on the floor.
NOTE: For units with Gas Strain Relief Kit (MF# 98-1421) refer to # 10.
10. Refer to the Installation Instruction provided with the Gas Strain Relief Kit (MF #98-1421) for recommended
mounting instructions for the complete Gas Strain Relief Quick-Disconnect kit.
NOTE: See figure for recommended location of I-bolt (see below). (MF #08-7839).
SECTION 7 OPTIONS PARTS LIST
7-6