Filter
Top Products
17
Quick Start Guide Cisco Aironet 1130AG Access Point
Assigning an IP Address Using the CLI
When you connect the access point to the wired LAN, the access point links
to the network using a bridge virtual interface (BVI) that it creates
automatically. Instead of tracking separate IP addresses for the access point’s
Ethernet and radio ports, the network uses the BVI.
When you assign an IP address to the access point using the CLI, you must
assign the address to the BVI. Beginning in a privileged EXEC mode, follow
these steps to assign an IP address to the access point’s BVI:
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
Interface bvi1 Enters interface configuration mode
for the BVI.
Step 3
ip address address mask Assignsan IP address and subnet mask
address to the BVI.