Filter
Top Products
19
Quick Start Guide Cisco Aironet 1130AG Access Point
Configuring Power
After connecting the access point to a power source, its status LED might be
amber, which can indicate that the access point is unable to verify that the
PSE is supplying sufficient power. In such cases, you will need to configure
settings on the access point or the switch to identify your power source.
Identify your power sourceand switch condition andthen make sure thatyour
devices are configured as indicated in the table on page 19.
Follow these steps to configure the system power settings using the GUI:
1. Open your browser and enter the access point’s IP address in the address
field. A login and password screen appears.
2. Enter the user name Cisco and password Cisco. The username and
password are case sensitive.
3. When the access point does not receive enough power for full
operations, it is in low power mode. If your access point is in low power
mode, a warning message appears indicating that all radios are disabled
due to insufficient power. Click OK to continue. The System
Configuration page appears.