Filter
Top Products
ENGLISH
20
WARNING
Before ANY cleaning or servicing of the oven, perform the following procedure:
1. Switch off the oven and allow it to cool. Do NOT service the oven while it is warm.
2. Turn off the electric supply circuit breaker(s) and disconnect the electric supply to the oven.
3. If it is necessary to move the oven for cleaning or servicing, disconnect the gas supply connection before moving
the oven.
When all cleaning and servicing is complete:
1. If the oven was moved for servicing, return the oven to its original location. Adjust the legs so that they are seated
properly on the floor.
2. Reconnect the gas supply.
3. Reconnect the electrical supply.
4. Turn on the full-flow gas safety valve. Test the gas line connections for leaks using approved leak test substances
or thick soap suds.
5. Turn on the electric supply circuit breaker(s).
6. Perform the normal startup procedure.
NOTE
ANY replacement parts that require access to the interior of the oven may ONLY be replaced by a Middleby Marshall
Authorized Service Agent.
WARNING
Possibility of injury from moving parts and electrical shock exists in this oven. Switch off and lockout/tagout the electric
supply BEFORE beginning to disassemble, clean, or service any oven. Never disassemble or clean an oven with the
BLOWER switch or any other circuit of the oven switched on.
CAUTION
NEVER use a water hose or pressurized steam-cleaning equipment when cleaning this oven. DO NOT use excessive
amounts of water, to avoid saturating the oven insulation. DO NOT use a caustic oven cleaner, which can damage the
aluminized bake chamber surfaces.
NOTE
It is strongly recommended that the 3-Month Maintenance and 6-Month Maintenance procedures in this section be
performed ONLY by a Middleby Marshall Authorized Service Agent.
SECTION 4 - MAINTENANCE