Filter
Top Products
Before using for the first time
^
Clean the inside of the appliance and
the accessories with lukewarm water
and a little washing up liquid, and
then dry with a soft cloth.
Important:
To ensure the correct functioning of
the appliance, let it stand for approx.
1 1/2 - 2 hours, or for approx. 8
hours if it has been transported on
its side to its final location before
connecting it to the mains.
Switching on
^ Open the appliance door.
^ Press the rocker switch on the
right-hand side underneath the
control panel.
The appliance will start to cool, and the
interior lighting will come on when the
door is opened.
The access sensor in the control panel
will also light up.
To enable the temperature to get
sufficiently cold inside the
appliance, allow the appliance to
run for a few hours before placing
food in it.
Do not place food in the freezer until
the temperature is at least -18°C.
Please note: Switching the
appliance off with the rocker switch
does not disconnect the appliance
from the mains.
Operation
A light touch of the finger on the
sensors is all that is required to operate
this appliance.
Please note:
– A sensor which is available for
selection is always highlighted in
white.
–
A sensor which has been selected is
always highlighted in yellow.
^
Touch the access sensor so that it is
highlighted in yellow.
Other sensors that are available for
selection will appear in the control
panel.
Switching on and off
15