Filter
Top Products
The ice/water dispenser must be
connected to the mains water
supply (see "Mains water
connection").
Use a suitable container to dispense
water and ice cubes into. Danger of
glass splinters.
Do not hold your hand under the
ice/water dispenser spout. Danger
of injury.
Switching on the ice/water
dispenser
Before it is used for the first time, the
ice/water dispenser pipework must
be rinsed through and filled with
water.
Rinsing the pipework
^ Open the appliance door.
^
Touch the access sensor to highlight
it in yellow.
^
Touch the On/Off sensor for the ice
cube maker to highlight it in yellow.
^
Close the appliance door.
It may take a few seconds after
opening and closing the appliance
door before the ice/water dispenser
is ready for use.
The sensor for chilled water will flash
white in the ice/water dispenser control
panel.
^
Place a suitable large container
underneath the ice/water dispenser
spout.
^ Touch the sensor for chilled water
until it flashes yellow.
^ Touch and keep your finger on the
sensor for chilled water again.
This will activate the rinsing function:
Approx. 6 litres of water will now be
pumped through the pipework.
You can interrupt the rinsing process at
any time to allow you to empty the
container by taking your finger off the
sensor for chilled water.
The sensor will continue to flash yellow
while you empty the container.
A beep will sound when the rinsing
process is complete and the sensors in
the ice/water dispenser control panel
will now be highlighted in white.
The ice/water dispenser is now ready
for use.
Ice/water dispenser
31