Filter
Top Products
Switching on the ice/water
dispenser
Rinse the ice/water dispenser
pipework before using it for the first
time.
^
Open the appliance door.
^
Make sure that the ice cube
container is correctly located
underneath the ice cube maker.
The ice cube container must be
completely shut for ice cubes to be
produced.
^ Touch the On/Off sensor for the ice
cube maker to highlight it in yellow.
^ Close the appliance door.
The ice/water dispenser is now ready to
use.
It may take a few seconds after
opening and closing the appliance
door before the sensors can be
used and the ice/water dispenser is
ready for use.
^
Activate the ice/water dispenser by
touching one of the sensors or waving
your hand briefly under the dispenser
spout. A light sensor below the spout
will register this movement.
All the sensors in the ice/water
dispenser control panel should now be
highlighted in white.
If this is not the case, the system lock
has been activated (the 0 sensor will be
highlighted in yellow, see "System lock").
If the 0 sensor is flashing, the drip
tray needs to be emptied (see
"Cleaning and care").
Once the freezer has cooled down to its
set temperature, the ice cube maker will
fill with water.
Do not place bottles or other items in
the ice cube maker to chill them
quickly. The ice cube maker could
become blocked and, as a result, be
damaged.
Discard the ice cubes produced
during the first 24 hours and do not
consume any chilled water or
ice/crushed ice during this period,
as the water will have been used to
rinse through the pipework.
This also applies when using the
appliance again after not having
used it for a while.
Ice/water dispenser
32