Filter
Top Products
Cleaning the milk valve
You should clean the milk valve once a
week to ensure good quality milk froth.
^
Touch "Main menu" or the # sensor.
^
Touch "Maintenance" y.
^
Touch "Clean the main dispenser".
The main dispenser and the milk valve
move into the maintenance position.
Important! Before you confirm
"Leave maintenance position" with
"OK", you must remove the cleaning
brush. Otherwise, the coffee system
will be damaged.
^
Insert the brush into the milk valve.
Move the brush back and forth.
^
Touch "OK".
The milk valve will move into the stan
-
dard position and the milk pipework is
rinsed.
Sensor cover
The sensor cover for the cup protection
shut-off is located under the main
dispenser. If the automatic dispenser
adjustment sensors do not clearly
recognize a container, the cup
protection shut-off stops the main
dispenser.
Clean the sensor cover by hand only
as necessary using warm water and
liquid dish soap.
^ To remove, press and hold the
sensor cover between the dispenser
nozzles a. Then press the main
dispenser in from the sides at the
back b.
This releases the sensor cover.
^
To replace, insert both hooks at the
back and press the sensor cover
upwards.
Cleaning and care
54