Filter
Top Products
Installation
33
To avoid scratching the deflector
lat
e, do not remove the protective
film between the deflector plate and
the casing until the hood has been
placed in the housing unit.
Installa
tion of the cooker hood is
carried out without the grease filter
placed in position. If the grease filter
has already been fitted, then it should
be removed (see "Cleaning and
care").
When fitting
a 90 cm wide cooker
hood in a 60 cm wide wall unit, whilst
the deflector plate is pulled out,
unscrew the two deflector plate
spring mounts.
Lift the applianc
e up into the housing
from below until the spring mounts at
the side engage in the brackets.
P
ush the cooker hood back against
the spacer strip.
No
te for dismantling the cooker
hood: Undoing the screws on the left
and right inside the housing releases
the spring mounts allowing the
appliance to be removed from the
unit.