Filter
Top Products
12. Light cover
^
Pull the deflector plate slightly out.
^
Tilt the front of the external filter
slightly down and out.
^ Insert the two holders on to the sides
of the light cover.
^
Secure the light cover using (2)
3.5 x 9.5 mm self-tapping screws.
Reinserting the external filter:
^
Remove the protective film from the
the filter frame.
^ Make sure that the red plastic guides
are at the front and facing up.
^
Insert the external filter into the
extended deflector plate from below
and hold it in position.
^
Push the filter gently upwards and
push the deflector plate in. The filter
will slide into the holders.
^
Push the filter backwards so it snaps
into place.
Installation
36